引用本文:屈刚,李长凯.配电网架空线路断线故障定位[J].电力自动化设备,2005,(12):35-38
.Fault locating of non-grounding line break in distribution network[J].Electric Power Automation Equipment,2005,(12):35-38
【打印本页】   【HTML】   【下载PDF全文】   查看/发表评论  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 3943次   下载 0 本文二维码信息
码上扫一扫!
配电网架空线路断线故障定位
屈刚,李长凯
作者单位
摘要:
对10kV配电网线路单相断线非接地故障进行故障定位探讨。采用梯形模糊数估计配变负荷变化情况。建立了单相线路网络模型。当断线相电流减小幅度超过设定值以及满足电压条件时,开始对此单相线路进行电流计算,计算出某节点流出电流为零的可能性最大后,即可确定此节点与其后节点之间发生了断线故障。该方法可缩短故障定位时间。
关键词:  配电网络  单相断线  故障定位
DOI:
分类号:TM711
基金项目:
Fault locating of non-grounding line break in distribution network
QU Gang  LI Chang-kai
Abstract:
A method to locate non-grounding line break fault of 10 kV distribution line is presented. A trapezoid fuzzy figure is adopted to estimate the load change of distribution transformer and the single-phase distribution network model is constructed. When the current decrease of broken line exceeds the setting value and the fault-voltage appears,the outflow currents of the load nodes on broken line are calculated. The fault point is between the node,which has the largest probability of zero current ,and the downstream node. The proposed method shortens fault locating time.
Key words:  distribution network  single-phase line break  fauh locating

用微信扫一扫

用微信扫一扫